Arduino Motor Shield Rev.3 Parallel Outputs for 4A-Current - Driving DC-Motor
good morning,
i operate arduino motor shield rev 3 1 dc motor.
i switch both outputs in parallel double current.
i looked @ data sheet of l298 , schematic of arduino motor shields, can not understand, how connect.
i know pins on motor shield, have wire parallel.
i grateful tip
best regards
raptor90se
i operate arduino motor shield rev 3 1 dc motor.
i switch both outputs in parallel double current.
i looked @ data sheet of l298 , schematic of arduino motor shields, can not understand, how connect.
i know pins on motor shield, have wire parallel.
i grateful tip
best regards
raptor90se
not easy do, have solder jump wires board sensa , sensb not brought out header pins.
i think if connect every signal in each h bridge together, might work... based on fact can solder l298n on top of double current.
so connect out1 out3
out2 out4
in1 in3
in2 in4
ena enb
sensea senseb (nb not sens0 , sens1!)
make sure enb, in3 , in4 set inputs don't conflict in1 , and in2.
i haven't tried this, if goes wrong burn l298n don't blame me. if you, 2nd , maybe 3rd opinion
i think if connect every signal in each h bridge together, might work... based on fact can solder l298n on top of double current.
so connect out1 out3
out2 out4
in1 in3
in2 in4
ena enb
sensea senseb (nb not sens0 , sens1!)
make sure enb, in3 , in4 set inputs don't conflict in1 , and in2.
i haven't tried this, if goes wrong burn l298n don't blame me. if you, 2nd , maybe 3rd opinion

Arduino Forum > Using Arduino > Microcontrollers > Arduino Motor Shield Rev.3 Parallel Outputs for 4A-Current - Driving DC-Motor
arduino
Comments
Post a Comment