DIYino Board Issues
alright need help. trying build saber diyino v1 board. trying configure mpu program won't upload. windows gives me error says , "one of usb device attached computer has malfunctioned, , windows not recognize it."
the error arduino ide when try upload program,
"avrdude: stk500_getsync() : attempt 1 of 10: not in sync:
avrdude: stk500_recv() : programmer not responding"
i have tried multiple mini usb cords, multiple board managers, , programmer correct one. also, no new port appears after plug in device. board lights windows error message pops up. i've been trying figure out weeks , still can't figure out. i'm starting think board defective, hope isn't case.
the specific light pattern of board 4 flashes when plugged in.
(no haven't tried file down left on bridges on board)
i appreciate , help.
the error arduino ide when try upload program,
"avrdude: stk500_getsync() : attempt 1 of 10: not in sync:
avrdude: stk500_recv() : programmer not responding"
i have tried multiple mini usb cords, multiple board managers, , programmer correct one. also, no new port appears after plug in device. board lights windows error message pops up. i've been trying figure out weeks , still can't figure out. i'm starting think board defective, hope isn't case.
the specific light pattern of board 4 flashes when plugged in.
(no haven't tried file down left on bridges on board)
i appreciate , help.
was intent tell board, schematic, photograph, or chip based on, or trying troll us?
Arduino Forum > Using Arduino > Installation & Troubleshooting > DIYino Board Issues
arduino
Comments
Post a Comment