LilyPad Arduino generates error but works if Genuino/Uno board is selected
hey...
i ran , thought worth posting. have lilypad arduino (with atmega328 chip) running dreaded
avrdude: stk500_recv(): programmer not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xfc
problem. tried virtually of remedies online. finally, tried "genuino uno" board in arduino ide , able upload sketch.
i'm posting if others run can give try - have ideas why works?
i ran , thought worth posting. have lilypad arduino (with atmega328 chip) running dreaded
avrdude: stk500_recv(): programmer not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xfc
problem. tried virtually of remedies online. finally, tried "genuino uno" board in arduino ide , able upload sketch.
i'm posting if others run can give try - have ideas why works?
sounds burned uno bootloader onto lilypad. you can continue use uno or burn lilypad bootloader onto it.
Arduino Forum > Using Arduino > Installation & Troubleshooting > LilyPad Arduino generates error but works if Genuino/Uno board is selected
arduino
Comments
Post a Comment